Skip to content

SARC INTERNATIONAL CONFERENCE – Proceedings

Papers

  1. Speed Synchronization of Master-Slave DC Motor Control System using PID Controller

    Yin Hnin Thet Htun, May Su Hlaing, Tin Tin Hla

    Paper ID SA-AEEE-PTYA-230123-3466 · Pages 41–81

    Abstract

    This paper presents speed synchronization of master-slave DC motor is tested with the various Proportional, Integral, Derivative (PID) controller configurations in software and hardware design. In simulation, the PID, PI-D, I-PD and 2DOF I-PD controller test to obtain the precise desired reference speed for the DC motor at least error. To get the mathematical model of DC motor, MATLAB system identification tool-box (black-box modeling) is used with the input/output data of the DC motor open loop control system. MATLAB Simulink block is used to test the speed control of DC motor software result. MATLAB built-in PID tuning Method calculates the Kp, Ki, and Kd gain for the various control algorithms. These gains are adjusted with manual tuning to get better speed performance of DC motor control system. In experiment, Arduino Uno act as a controller. The communication protocol between two DC motors uses I2C (Inter Integrated Circuit) communication. The hardware experiment shows the speed response of the master-slave DC motor with the PID controller at different reference desired speed. Keywords - PID, P-ID, I-PD, 2DOF I-PD, DC Motor, Master-Slave

    Download PDF
  2. Development of GPS Signal Tracking on Software-Defined Radio

    Han Nilar Htay, Zin Mar Lwin, Tin Tin Hla

    Paper ID SA-AEEE-PTYA-230123-3467 · Pages 48–95

    Abstract

    Global Positioning System (GPS) receivers are of great importance for the increasing demands of location-based services in both the civil and military fields. GPS satellites broadcast on L1 1575,42 MHz and L2 1227,60 MHz carrier frequencies. In this paper, signal analysis fixated on the L1 band. GPS receivers can be executed by using software defined radio techniques. The reconfigurable software defined receiver developed makes use of RF front end called Hack RF One. Software Defined Radio provides a prospect for scalable and gainful of GPS signal acquisition and tracking. A software-defined GPS receiver has been designed which is based on a combined hardware and software platform. The hardware platform, Hack RF One based recording and tracking system is low cost, portable, and can be reconfigured to record and track the entire family of GPS signals. When realizing software experiments, an interface called GNU Radio has been used because of its enormous implementation of signal processing blocks. The GPS data recorded using Hack RF One base blocks from GNU Radio and provides computed acquisition and GPS tracking solutions in MATLAB. Keywords - GPS, GNU Radio, Software-Defined Radio, Hack RF, Tracking.

    Download PDF